Links Corner Forum

Well folks I knew it wouldn't last.
My APCD is letting me do a limited number of commands and then locks up.
I have no clue as to why.
I can do a complete new install and all is good so it must be some file doing it.
As a result I'm going to try and complete the 3 courses I have going and then I will be starting over AGAIN...!!!!!!!!!!!!!!!!!

I am obviously a glutton for punishment...!!!!!!!! I love it folks...!!!!!!!

Wish me luck in my future torture....................

Sage......

You are not having a good run there Sage.

When my own systems keep having unexplained problems, which seems to happen after some years of use and I get fed up with it, I usually bite the bullet, go back to basics, wipe the system completely and reinstall everything starting with the Operating System. I've done that with my old Windows 10 systems a couple of times before I turned them into Linux systems.

If I am nervous about it I will swap disks and set it up on a new disk.

Windows systems do seem to get tired and problematic with age.

Des

Des,
That is what I did a few months ago. Installed my windows 10 over my windows 11. Clean complete reinstall.
It's a APCD thing I am sure.
I'll just keep abusing myself cause it's so much fun. I don't even get mad anymore........

Sage........

Sage,
From one glutton for punishment to another, I hope you can complete the three courses without any more problems.
It is wonderful that you can still see the positive side of APCD.
Good luck, and many
Ian

Sage & Ian, you guys amaze me with your commitment to still producing quality courses

I've just lost interest, as the courses I would like to create are for the DP World Tour and there just doesn't appear to be the lidar available as far as I can see. I also don't have time for making loads of 3D stuff, as I still play at least 12 rounds a week along with running a tour at LSPN.