Links Corner Forum

Been working on this course for close to a year. Went to make a new trap on hole 10
and i noticed the traps have some gray faces in them. After further checking all
terrains have some darker faces. Then i noticed whenever there is a height change
between the verts, the face gets darker. the more severe the height change the
darker the face. I thought i could fix this but im lost . the terrain properties
are correct. You can even see the edges protruding thru the terrain. The course had been ok, then this happened. i must say after hole 9 i got in to 3d building for my first time.
I read DeShanneys tutorial an had a blast. So far my work is poor but im learning.
I did make about 6 buildings that are on the course. The course worked fine after
the 3d work was done. So i don't know . I have included a pic for example.

thanks
Doug

Doug - that's not shadows?

Pete

It looks like all edges were turned to hard edges (sharpness 4 or -1) during the 3D work. Select the edges for the course and soften to sharpness = 0.

Thanks for the help the guys. That must have been what i did.



Doug

Surface Springs should be ready this year. Unless i make
another huge blunder . I have encluded a pic. It is of
hole 12 a par 3.

Doug

MasterMontgomery wrote: ↑January 9th, 2025, 1:05 am Surface Springs should be ready this year. Unless i make
another huge blunder . I have encluded a pic. It is of
hole 12 a par 3.

DougThe 12th.jpg

Wow! Looks great!