Page 3 of 7
Re: Close House Colt Course
Posted: May 31st, 2020, 3:34 pm
by GoBucks
Depending on conditions, pin location, tee selected, and the surrounding area (especially the left side), I think that circle of fairway could come into play. Even for pro clickers. If it's playing downwind, I would consider landing it short of the green if the pin was on the front part of the green.
Just another thought.
Re: Close House Colt Course
Posted: May 31st, 2020, 7:44 pm
by Stephen Sullivan
Re: Close House Colt Course
Posted: June 1st, 2020, 12:34 pm
by GoBucks
Totally misread the first post and the "circle of fairway." I was only considering the fairway around the green.

Re: Close House Colt Course
Posted: June 17th, 2020, 8:37 am
by Stephen Sullivan
Re: Close House Colt Course
Posted: June 17th, 2020, 5:37 pm
by sagevanni
Hi Stephen,
I LOVE your vert work shown in untitled-1.jpg......!!!!!!!!
I am going to try it on my new course.......Thanks for showing......
Sage.....

Re: Close House Colt Course
Posted: June 17th, 2020, 7:57 pm
by Stephen Sullivan
Sage
Still lots of verts to go in for some of the seams on that shot. The paths came from something Derrick and Danny talked about regarding blends and extrusions. I do prefer as neat a mesh as possible though.
Re: Close House Colt Course
Posted: June 19th, 2020, 9:35 pm
by Stephen Sullivan
Finally got all the main textures in. Think I will have a look at the flybys and try and get at least the green areas as good as possible before I seriously start on the blending (except for some of the outer forest and field areas)
Re: Close House Colt Course
Posted: June 19th, 2020, 10:33 pm
by Pete
Many thanks Stephen, looking real good
Re: Close House Colt Course
Posted: July 7th, 2020, 7:34 am
by Stephen Sullivan
All the main blending is done. Now to try and figure out the blending for the many bunkers

Re: Close House Colt Course
Posted: July 8th, 2020, 10:29 am
by Stephen Sullivan
49 more bunkers to get to this level of mesh, before starting on the blends.

- Untitled-1.jpg (197.96 KiB) Viewed 6691 times
Think I am going to use Lez's technique and create a bunker lip texture with the three textures in one. Will have to make two as some bunkers have rough and some have deep surrounding them.
I could be some time
