Attached are two images... The first is the overhead view showing that I have defined a hole path for this hole. The second is the error message I get when I try to place tees and hole. I followed the instructions and recreated the hole path five times now with the same error message when I retry placing tees and hole. Any ideas how to get out of this loop?
Wojo
Cannot Place Tees and Hole...
Cannot Place Tees and Hole...
- Attachments
-
- I Have a Hole Path.jpg (376.77 KiB) Viewed 1912 times
-
- Cannot Place Tees and Hole....jpg (371.18 KiB) Viewed 1912 times
Re: Cannot Place Tees and Hole...
Wojo,
Make sure your textures are tee, fairway and green.
Make sure you use this....
Open this dialogue.....
Set to bottom radio button.....
Hope understand and this helps....it should work......
Sage.....
Make sure your textures are tee, fairway and green.
Make sure you use this....
- Capture-1.JPG (108.99 KiB) Viewed 1901 times
- Capture-2.JPG (31.03 KiB) Viewed 1901 times
- Capture-3.JPG (36.74 KiB) Viewed 1901 times
Sage.....
If there is one thing ................ummmmmmmm.......I can't remember.
Re: Cannot Place Tees and Hole...
Perfect... Thanks.
Re: Cannot Place Tees and Hole...
Wojo, I hope it all works out.......
Sage......
Sage......
If there is one thing ................ummmmmmmm.......I can't remember.